Search results

If everyone who made a mistake was only given one chance, there wouldn't be a single mechanic. I for one dont like making repeat mistakes. Instead I find new and creative ways to :censoredsign: stuff up. There is another fuse box, either above batteries, behind driver's step, or just behind...

P081b Starter disable circuit high. Pretty much this code is set when something is left unplugged or if the starter cut relay has died. The first step is to charge the batteries. If you decide to jump start it, leave the jumper cables on for a while first. Like 15 minutes. They don't like...

Check the room light fuse in the outside fuse panel. Also recharge the batteries before trying to restart it. They do not like low voltage.

I was 100% wrong. Phillips head screwdriver. Access holes on underside of hood. Phillips turns gearwheel. Doing this right now in rest area for first time.

Watching her climb in and out is both hilarious and terrifying. She's gonna bust her ass if she doesn't use both hands. In general, she's terrified. She refuses to drive it.

Im currently driving a 2008 268 to Florida for...reasons. The spring suspension is making my wife's boobs bounce all around which is a constant source of entertainment. For me, anyway.

You'd probably want to verify that for sure, lol.

Check itv for wear and proper modification. This sounds like a failing dpr temp sensor, or a break in the harness side of one of the temp sensor connectors. Inlet side harness wires most prone to breaking internally, generally within an inch or two of the connector. Vibration causes the wires...

Unlike everywhere else, im sure we have that seal in stock.

I don't know why no one has the seal. The tone rings will totally rust away over time.

Air or hyd brakes? Either way, you're gonna need to put that corner on jackstands, get the wheels off, the axle out. If hyd brakes, you're gonna need a 30mm wrench to get the rear caliper off. Set it on a 5 gallon bucket so you don't mangle the hose. If air brake, back the slack adjuster...

That is always a possibility. It's hard to quote a wheel seal repair, as half the time you find trashed bearings too.

The axle is a Meritor. Any truck place should be able to fix it. You don't have to use a Meritor seal, a Stemco will work fine. A lot of truck shops have a pile of these in stock.

There's none in stock in the US, I can have one flown but the air freight is outrageous.

Not sure. I think it's 3 micron. It's small, keeps water droplets from passing through.

The first plasma: the Wendelstein 7-X fusion device is now in operation This is an experiment to test stellarator field magnet design to see if it's suitable for wide-scale fusion power production. It took close to 30 years to design and build, hampered in part by the lack of 3D computer...

That...was scathing. Bravo!

Instead of trying to get better, now I'm installing a liftgate. In my driveway.

If the sensor's part numbers end in either 0020 or E0450, yes, replace them. The newest sensors end with E0451. If you have the new sensors, well, things get a little more vague. DEF quality, DEF injector spray pattern/leakage need to be evaluated. Air getting pulled into the DEF pump is a...