Recent content by HinoRich

I have the same code P204F and CEL but my truck runs fine. It started doing it one week, then went out the next week and has come on again but the truck continues to run fine.Could this be a bad sensor or bad DEF? I mean for the P204F.

Thanks for the reply. I just thought it was a little strange for this to happen to a 4 year old truck. The truck is not abused by any means. I feel better knowing it's a common issue but don't feel better about the $4500 bill...

I have a 2107 268 with 96500kms So I had an oil leak so I dropped it at my local Hino Dealer. Here is what they found... We found the rocker box and the oil pan gasket are leaking and will need to be replaced. We would need to order the injector pipes from the United States, two to three days...

Thank you very much for your help. When the part arrives, I can get it on and stop the beeping. You sir are a great asset to this site!!

Ok great! When I install new motor/pump, do I need to fill it with fluid before I install, like an oil filter? Or just let the system pump the fluid to it? I'm pretty certain it's the motor/pump as when I tap the end, the light and beeping stops but as soon as I turn the truck off and restart...

I attempted to take the round motor that is underneath my master cylinder as I need the product # off it as it seems it's hard to find the actual one of these I need. I started to unbolt the bolts and fluid starting leaking out of it, which I was told wouldn't happen. I'm just wondering if...

There were no leaks until I unbolted the 2 bolts from the bottom of the master cylinder. 12 volts to the connection? Every once in awhile, the light does go out but it comes right back. I have checked all the connections around the area. I was told there was no fluid, where the aux motor bolts...

I'm wondering if someone can tell me why there is red fluid(auto transmission/power steering fluid coming out of the bottom of the master cylinder when I started to unbolt the aux motor/backup pump from the master cylinder to replace it? I understood there was nothing more I needed to know, when...

I have found the motor, mine is on the driver's side right under the master cylinder. I have found them online but I'm not sure it it's the exact one I need. I can't see any numbers on it so I can let someone know what part I need to order. I explained that there is a motor underneath the master...

I checked all the wires again. I had someone push the pedal as you suggested a few times and I did feel and hear the relay click.I tapped the aux motor a few times with no luck. Is there a fuse to pull so the beeping stops? The Hino mechanic at the local dealer only works 3 days a week and...

Thanks, I will give this a try tomorrow.

I have a 2017 268 and there is a red exclamation light on the dash and a constant beeping. I looked it up in the manual and it has something to do with the hydraulic brake system. I have no aux brake motor sound at startup. I cannot push the pedal down, when truck is not running. I have looked...

Ok. Thanks! I finally got the new relay from the dealer today and it seems to have solved the problem. It started every time, no issues so far. Thanks again for the info.

Now today I have a new issue with the truck. Codes Inactive U110A P204F At one point the SVS light came on and it went into limp mode. I turned the truck off, did a delivery and when I started it back up, SVS light went out but CEL came on and the truck worked fine. This truck is really...

Gotcha! Going to look into this tomorrow and try to get one from the Hino dealer or get them to order one. By any chance, is there any way to test to see if the relay is bad or just replace to see?