Recent content by rhitrucking

as requested a pic of the truck

I thought i fixed the issue, but its back doing the same thing. I am getting no sensor faults so I am a bit perplexed

thanks for the heads up. We found the issue, it was a bad connection on a rear abs sensor.

So I stretched a Volvo VNL Ishift daycab to accomodate a 26ft body. Everything turned out fine, except now I have this weird issue. When turning from a dead stop either direction, I will get a complete dead spot in the throttle response for like 3-5 seconds. This only happens when turning...

Message sent

Check engine light back. P1459 is the code. truck has no power, barely idles. turn it off and it runs fine for a while, albeit in limp mode. I think a valve is not working or stuck. runs fine when cold, but after it warms up all heck breaks loose until it is turned off and restarted

the dpf was replaced due to a recall. The truck finally gave me a check engine light for the temp sensor. I ohmed the first one and it was 140 ohms. ohmed the 2nd and it was at .210. The new one fixed it. BTW the new one ohmed at .219

fixed with a new temp sensor. not cheap little things, but back running

Had the DPF replaced about 60k miles ago. Just recently, when watching the bar display for dpr, after getting to 1 bar, it jumps to 3 bars within 10 miles. I am getting about 70 miles before it regens.

I am looking at buying a used commercial truck in the Hartford CT area. Since I am across the country I was wondering if anybody knew of any reliable inspection companies in the area? I know its better to do it myself, but I just dont have the time to do it and was hoping to get a reliable...

how on earth do you get the inside bolt off the scv without dissasembling everything?

Tobster, what year and model was yours?

hopefully someone can help me. The radiator on my 2008 338 is about shot and has a small leak. It seems the part number for 2005-2007 is 16400e0070 and for 2008 16400e0260. However, most places that sell radiators are saying 2005-2008 are all the same. What if any is the difference?

My 2008 Hino 338 has recently had the check engine light come on twice for code P0087, fuel/rail pressure to low. My rail pressure is about 26,500-27,000 psi at 65mph and at idle its about 8000-9000psi. Are these normal figures and What normally triggers the p0087 code?

How on earth does one get the Starter off? Where and how to get to the hidden bolt?