Recent content by ud2600bbs

I’ll check on that since after the truck warms up works fine it’s only when the truck is cold that it does the issue

Hello Hino123 i changed the Maf for a genuine hino and nothing change the engine starts up fine after two minutes Rpms start decreasing and the engine won’t rev even if you press the pedal

Thank you

Thanks for the response i will monitor the injection quantity when cold also injector balance. And i will try another MAF I suspect the egr valve but i will Digg in and come back once i test everything let me DM you my email

man i am in California and this is the only UD with hino engine i had to get the software because is rare the shop that has it

Hello thank you for the response yeah its a weird issue the truck has about 500k but it has new injectors new pump with new scv i have tapped on the side of the scv but no change and the issue is only when the engine is cold starts fine about 1 min warming up the engines Rpm start dropping and...

Hello everyone i have a 2008 ud with J08 and the problem i have is when the truck is cold in the morning starts fine after like q minute of warming up the engine Rpms start dropping and the truck wont accelerate and there’s black smoke coming out the DPF the weird thing is if i start the truck...

Looks like the same issue i had with my UD do you get a check engine light? I use to have power loss and ended up being injectors fix that and a couple days later my HPFP went bad after that the truck works fine where are you located i have the ud software

You need UD Data Link software to scan the truck and see what codes you have registered Check if the ITV isn’t stuck or any clogged fuel lines maybe bad scv or bad turbo

You should check if your ITV is drilled also check the scv valve if you have the updated part check banjo fittings and fuel lines maybe clogged

Hey Greasyshirt thanks i found the elbow on the tank clogged but i had replaced scv and fuel filter before trucks runs good now

Hi haven’t posted in a long time i an having a issue on a 2008 hino 268 have no check engine or codes the truck lost power and you start accelerating the truck surges and you floor it and it wont go i do have an ABS light on was givinv R wheel sensor circuit changed that Now i get 2-2 and its...

Hey thanks gredytshirt i replaced the 7th injector and installed the new dpf because the old one was really bad and forced a manual regen and that fixed the issue thanks for the help

Thank you greasythsirt I will check that i will also get the dpf baked it need cleaning at 155k almost there