Search results

Looks like this is something that I need to check into. There is nothing going to the block heater from the apu. I just tried to plug a cord into the inverter then into the block heater plug. Thanks for the info Dave.

I also have a Tri pak. It works good only had to replace the belt on it in 4500 hrs. The only thing I don't like about it is you can't get enough power. The alternator dosen't put out enough juice if you need a lot of power. I can run the microwave for a few minutes then I have to start the...

I've got the same wear pattern but it's on the passenger inside drive tire. No body could tell me what caused it. Even had the rear axle alignment checked and it was fine.

Thanks for the response Dave. Guess I'll leave everything as is.

What’s the reason for the APU to shut off when you turn the key on? There is a wire going to the fuse box that is plugged into a “ignition on” spot. So whenever you turn on the key to start the truck the apu will shut off. Can I unplug this wire with no damage to the unit? Would be nice to leave...

Ok have to admit i'm kinda slow. :D Sorry i finally found it in the classifieds. Its a really sharp truck.

If its a must see why not show it off.

Not planning on it. Maybe in the future. Just had apu put on. The sticker on the door shows 12000 for the front. Was close to that but the apu made it go over. They put it as far to the back as they could. When load i put everything over the center of the rear axle Painted a white line on the...

No a single axle century. Now what about the states your only allowed 12000 on the steer. Will they still give a over weight ticket if your empty?

Ok i have a question now. What if your at 12400 on your steer when empty. Thats with both drivers and all stuff in truck.

Ok this might be a stupid question. I heard about riteway onboard load scales. Could you put this on a class 8 st. It already has the air ride gauge on the dash. But with this would you know how much weight is on the front axle. Had several loads i was over weight on the front and had to get...