Search results

It's an automatic and yes you can here the clicking in the fuse panel.

Thanks for the reply!

The truck ran for 10 hours + and then wouldn't restart after shutdown. It will start with key on using a screw driver to jump the solenoid on the starter. Any ideas?

My 2013 268 ran fine all day and then once I shut it down it would not restart. If you jump the solenoid on the starter with a screwdriver while the key is on the truck will start. Is there a sensor or something you can recommend?

Hello, my 2013 hino 268 was shut down for lunch and then wouldn't start again. With the key on you can get the starter to crank by jumping the solenoid with a screwdriver. Apparently I have a sensor or something that went out? What can you recommend?

Greasy....shirt I replaced all three sensors on the service brake replay and the brake pedal switch is working fine. When the engine is off you can hear the brake pedal sensor clicking some type of solenoid as if it's functioning fine. Unfortunately this problem continues. If I let off the gas...

Ha, okay. I was just hoping they weren't like $800 each. M Thanks again!

What's the typical price of these switches on the service break relay?

Greasyshirt, I asked a couple questions a while back about my hino 338 with 440k and got great feedback from you. "Thank you!" My issue I'm having now is when stopped at a light with a small load (2,000lbs) or full load (17,000lbs) once I let go of the break and press the gas the truck just...

What does that service typically cost? Unfortunately I only have access to one Hino dealership that I'm aware of and they charge $165hr

greasytshirt I have an 08 hino 338 that had a head gasket done at 425k . Since its return my employee has put 5k on it and has failed to tell me that the DPR has been at 10 bars. As soon as I drove it and felt the power loss I pulled it out of service. The re-gen light will not come on to...