Recent content by Trkmed

  1. T

    Guidance needed 2005 Hino 268 ABS

    Okay, so I switched the pins from R/F to L/F and the code comes back as 2-2 , I clear the codes and after about 2 minutes off idle time the abs light is on it’s the 2-2 code, I will be looking for a control unit.
  2. T

    Guidance needed 2005 Hino 268 ABS

    I am thinking it is the ECU as the modulator itself pin out as good on the modulator pin 8 and 13 outlet valve is about 3.4 ohms pin 8 and 12 inlet valve is about 6.4 ohms (unplugged.) the ECU end of the harness with the modulator plugged in is pin 3 and 2 inlet valve 6.5 ohms and pin 3 and 1...
  3. T

    Guidance needed 2005 Hino 268 ABS

    Hydraulics, modulation valve ohm ok , control unit in the cab under fuse panel right side of dash. I am using the wabco maintenance manual 39. Maybe a more complete manual is out there. i just have the single truck as it was basically given to me. thank you for your time.
  4. T

    Guidance needed 2005 Hino 268 ABS

    Thanks, I Do have the manuals, but I cant seem to find the part that talks about the ABS module failure Or troubleshooting the module. i don’t mind getting the software but I am trying to keep cost on the low end as the truck is not a money maker for me. just for fun
  5. T

    Guidance needed 2005 Hino 268 ABS

    Hello, I recently acquired an 05 Hino 268 with Allison transmission. The truck had low power and The ABS light on. i am thinking the two are related. I have no code reader for this truck but pulled the blink codes. hydraulic brakes ABS code 2-2 left front modulator valve I checked the ohms on...
Top