Sign up for The Wire Newsletter!

Recent content by Marauder

  1. M

    2008 Hino 268 no power

    Also noticed oil level is way over full bar
  2. M

    2008 Hino 268 no power

    Got another Hino, and still nothing to hook up on. Intake air flow kinda low - 30g/s, 2000RPM reaches 100g/s, while good Hino idling 60g/s and reaching 2000RPM -145g/s. Switched MAF sensors - nothing, same numbers. No smoke nothing, engine in Limp mode.
  3. M

    2008 Hino 268 no power

    Will go on the test drive and put pictures. Only idea get another Hino and compare all parameters. Injectors? I will check the boost pressure sensor. Thanks!
  4. M

    2008 Hino 268 no power

    Turbo spins with hand freely. Also tried spinning it with air compressor - no binding. Checked EGR - it's closed, and moving without problems. Noticed that crankcase filter is missing. Out of ideas
  5. M

    2008 Hino 268 no power

    Throttle valve is full of oil. Despite that plate moves freely, it is tight on the shaft. Also there's three holes in the bottom. Turbo spins with hand. I'm out of ideas :/
  6. M

    2008 Hino 268 no power

    Unplugged MAF, to double check - no change. I also removed air filter box to check for any damage, replaced air filter. When I drive I can hear turbo spinning. Removing throttle vale, to check the condition of it. Checked everything fuel/air/exhaust related.
  7. M

    2008 Hino 268 no power

    Just run fuel leak inspection - 1500RPM Common Rail Pressure 21715PSI, Target Common Rail Pressure 21750PSI, no problems with fuel
  8. M

    2008 Hino 268 no power

    I doubled checked with DX2 - Brake Switch 1 - OFF, Stop light switch - OFF. Target VNT opening matches VNT actual opening. On Idle VNT 77%, pedal down all way - 68%. EGR all good also. What is ITV? Thank you!
  9. M

    2008 Hino 268 no power

    It is air equipped. I started from brake switch and lamp switch - shorted the one on rear axle, and removed brake switch from pedal, so both shows OFF. Zero change. DPR shows 1 bar. It's not trying to do regen.
  10. M

    2008 Hino 268 no power

    Also noticed pump control mode 2 - Start mode (low rail pressure)
  11. M

    2008 Hino 268 no power

    Hello, new member here. Have 2008 268 Hino, which has no power. No fault codes. Max 2000RPM, max speed 35MPH. Limp mode. Checked brake switch and stop light switch, replaced fuel filter, checked fuel lines for debris, removed exhaust, engine brake, checked DPF for clogging - all good. Have Hino...
Top