Recent content by igor

I should probably mention earlier that we cleaned egr. It had some soot there. Thanks again for all your suggestions

We finally got back to this 2008 338 with lack of power issue. Took dpr a part. The filter has some weird damage on outlet side. It's like a thin crack alone its outline. And also you can see some small melted particles I don't have a good closeup picture, but here's some: We replaced it with...

Also, forgot to mention the turbo has some oil in it, not too much thought. Looks like there's no excessive end play Right now ordering that greese spray you suggested for turbos at amazon

Thank you for reply We've checked intake throttle and it does have three holes in it, that was some oily residue in there we had to clean up Also, had rubber pipe between turbo and mass flow air sensor loosed and damaged (from swinging around). Replaced that. Then have found some free end...

Also, how can one purchase Hino DX II? should I be a dealer for that? Thanks for your time. You should post some address where we can send you a beer or some vodka

Hi greasyshirt, we have 2008 Hino 338 that has a power loss problem when I push accel.pedal to the floor the check engine comes on very quickly considerably less power then it was, at auto regen - 40mph Went to the dealer. they gave us mind blowing estimate after scanning. Just want to...

I'm gonna need a lot of time to absorb all this. Thanks a LOT. I'll post how it turns out with the DPF. Unfortunately, the whole week I am fighting with DX. For some reason I can't get Data Monitor working, it gives me an error of "Invalid Pointer" when I set up parameters in Monitor signal and...

Thank you for reply. I PMed you yesterday.. sorry for the confusion there.. Unfortunately, I couldn't figure out how to download 'burner event log'.. I've read all the discussions here, could miss it thought. Also, couldn't find 'amount of pm piling up' in our DX (checked all configuration menus...

Hi Greasyshirt, Thank you for all the work you are doing here. I have read about 4th part of these (will continue) but didn't find yet what I am trying to solve. our small company has 4 fresh Hinos 10-13 two of them have DPR lights we have recently purchased a Hino-Bownie adapter and Hino DX...