Recent content by apollopaul

Yea they are ripping him off!!

I to live in Mich. 33,000 lb straight truck IRP is regestered for 36000 lbs cost $674 for the year.

This is not a seal problem! It is a injector cup problem. The cups need a special tool to be replaced. I just went through this in Dec. Any good repair shop can fix this. Cost was $500.00 all new cups and injector seals since they had to come out. Good luck Paul

Small 8 in mirrors draw 2 amps. The large mirrors draw 3-4 amps. You can connect mirror wiring together inside the door. Besure to use good connectors or solder it up. BE SAFE Paul

Try a Bible and maybe a cross.

I drilled a 1/4 hole in cover and use 70-80w oil instead of grease. Be sure to plug hole with body plug so water can't get in.

The system is 12v chain drive. It still allows 2 speed trans unit in landing gear to operate. I have a toggle switch that runs unit up and down. It has a red led on the dash warning you the landing gear is in the down position. I hope all drivers use their landing gear, it's safer for the truck...

I have designed and built power landing gear for my straight truck. After slipping on ice in Dec of 08 and splitting my head open on the door cranking the gear up, I decided to add power to the gear. I checked online to find one company that sells them for $1200.00. Which is to much money. I...

My truck has fiberglass doors so the mirror brackets are not grounded. I had same problem, I went to no ground plane ant. from firestik. It works great

Do you have tabs on the roof also. I have them on my truck and love them. They take the wind and calm it down. Big rigs would knock me around before installing them. Nice pics

I would like to have some loads so I could see if I would get paid. Down $5000 from 08.:eek: