Recent content by suddy

Here are some of the pics. All of the sensors appear to be good, it looks like it is just heat shield damage. We are being told that you have to buy part by part for the DEF assembly.....do you know of anywhere to purchase the entire assembly together? It appears to be a little twisted as...

Hey Greasy, we got a 2016 386 that was hit on the front right and had the wheel pushed back into the DEF. the DEF tank is not salvageable. The exhaust and converter are a little banged up (can't believe the amount wiring). I was wondering if you think it would be workable if we showed some pics?

Hey Greasy, I have a 07 Hino with Automatic Allison transmission. It appears to be blowing fluid out of the vent. The light comes on occasionally. When you pull over and restart the truck it is fine. Fluid looks good and the level is good. Any know causes?

Tobster, thanks for the question.....it has been cooler here in the mornings with more moisture in the air/dew. The light does not come on every day. It has been like 4 times in the last 2.5 weeks. It always happens early in the morning/trip. Our driver pulls over, turns off the truck and...

Greasy, thanks for the info. I do have a Snap-on scan tool (solus ultra). I can communicate with the ecm and engine, but cannot get an stored codes or transmission information. Do I just need to get an update for light/heavy duty trucks?? Again, greatly appreciate all your help

We have a 2008 Hino with the Allison transmission....the transmission light has came on a few times....fluid level is good and clean....turn on the truck and start it back up and the light is gone and the truck runs fine.... any possible causes??

Thanks for your help. After sand blasting the tone rings,and breaking loose the abs sensors, and adjusting the sensors. The abs light has stayed off. I called the HINO dealer and asked for the TSB bulletin on ABS system. She informed me that TSB bulletins were for dealers info only. Thanks again...

What about rotors and pads for the rear of a 2008 hino ? Can those be picked up at autozone?

I will sandblast input rings,and check wheel bearings. The ABS code that comes up is sensor gap. My ABS sensors seem stuck fast . I will have to take them off and try to loosen them up,to make them adjustable. This truck goes out on long trips and i just don't want to hurt transmission with ABS...

Where do i get the kit ? Paid dealer $500.00 five months ago to scrap rust off one side on rear. Light coming back on. Pickups look like petrofied wood, they are rusted so bad. Hydraulic brake system with brake rotors on rear. Thanks

Are rear abs sensors adjustable on 2008 mickey hino 268 ?