Sign up for The Wire Newsletter!

Electronic Issues with 2008 Hino 338

Discussion in 'Hino Trucks' started by Tom from the Mitten, Feb 10, 2018.

  1. Tom from the Mitten

    Tom from the Mitten New Recruit Owner/Operator

    Joined:
    Feb 10, 2018
    Messages:
    1
    Trophy Points:
    1
    Ratings:
    +0 / 0 / -0
    Hello everyone,

    Seeking some help. Have a 2008 Hino 338 with electrical issues. Specifically not getting any electrical current to the following: EGR, throttle position sensor, and the air flow sensor. Also the engine brake appears not to be working. Anyone else experiencing or have experienced these issues occurring at the same time?

    Thanks,
    Tom
     
  2. greasytshirt
    Dr Pepper Addict

    greasytshirt Moderator Staff Member Mechanic

    Joined:
    Dec 3, 2013
    Messages:
    2,097
    Trophy Points:
    200
    Ratings:
    +711 / 0 / -0
    I'm looking at a wiring diagram. There are two wires coming from the ecm and they eventually touch every one of the devices you've mentioned. For all of them to be affected at the same time, the fault would have to be inside the cab, if the diagram is to be believed. Possibly at a junction box.

    Some wire chasing might be involved. In the meantime, see if there's corrosion inside the junction box under the air filter. Don't break the cover bolts if you can avoid it. Inside the cab, be suspicious of anything that looks like it's been spliced into, like for CB radios, gps devices, etc.
     
    Loading...

    Share This Page