Search results

In that case I guess I might as well go all in on this since the ABS faults have already started... Will let the dealer do the job... I want to take the time to say to you sir, that being a newbie, it is really great having someone to give me some advise, especially since the repairs almost...

Thank you very much for your expertise and time GTS... I think I will just tackle the pads this time... For future information, at what thickness would you usually recommend replacing the rotors? Thanks again.

Still a newbie...have patience. I recently had my truck serviced and there are some things I would like to double check. The rotors are at 36.75 (front) and 36.83(rear). I definitely need to replace the pads (6mm and 5mm) but would like to ask if I need to replace the rotors as well (they are...

Thanks for the speedy reply. Hydraulic brakes...and the drum is on the front of the rear end.

Hello again...Newbie here...My parking brake needs to be tightened on my 2012 338...I searched the forum for related posts and found the 2007 338 posts...is the adjustment to be found in the same place as the 2007? If not can you please tell me where it is and any recommended steps to adjust it...

Tapped them in with rubber mallet...ran it all day with no ABS light...NICE! I only run this truck 3-4 days a week on average...could this be a contributing factor to the rust formation? What are the things(if any) that I should be on the look-out for on a truck that is so lightly used? I bought...

Thank you, I will tap them in... On the subject of when the light goes on... it does almost always stay off at higher speeds and will come on once the speed drops to 20-25 mph. I knew about the tranny issue so I pulled over and shut the engine down...but since I needed to get back to the shop, a...

Can anyone tell me the recommended gap between the ABS sensors and the rotor on my beast (2012-338)? I had a lot of rust on the rotor and was getting an ABS light once in a while...I have cleaned the sensors and most of the rust... Thanks in advance.

Thanks for the help GTS ...as it turned out there WAS power on the drivers side as well...it was the wrong Trucklite replacement that was installed (by the dealer, would you believe?)...they used an 'H11' which is 'stop and turn only' according to the text right on the part...the original part...

I have a 2012 338 and the running light on the passenger rear works but the drivers side does not. All other functions (turn signal, brake, and hazard) work on both sides. Is this most probably a relay problem or a broken wire? (I have read that the power crosses over from the right light to the...

After reading your post I decided to fill the def fluid to the 'full' mark indicator on the tube, so I could confirm my suspicions. It has not dropped at all...I have driven almost 200km mixed city/highway. Any ideas?

Hello greasytshirt...I've spent some time reading this entire thread...very educational...many thanks! I am a new owner/operator of a 2012 Hino 338 with 110,000km in Canada. I have worked on my own cars with the help of repair manuals but never on a truck and never on a diesel. I have had a...