Search results

Where are u located and what weight capacity and platform size are u looking for?

What do these cameras look like can u share some pictures of ur setup

I'm thinking u were referring to other thread on Liftgates. For 6-8000lbs capacity would have to be a railgate and most railgates block your back door so u would lower it to open the door every time needed or not.

I bought a used Maxon 3000# aluminum platform double cylinder tuckunder off of a 2012 written off International, condition was very good didn't look like it had much use for $2500. I looked at it first and seen it operate and then told the dismantler where to cut the frame under the box and...

What sort of weight rating are you looking for? just remember you can always find a very good used one for a fraction of a new one.

Which Hino engine is she rebuilding?

Only difference between FF and FE is the axle weight rating, FF3020 was 30,000 and FE2620 was 26,000. I think the FA and FB are the same thing only difference is axle weights.

Thx. But I was told the 2000 FF had a at545 and most likely the FE as well, it's a pretty weak tranny for that size of truck. For FA and FB it would be perfect for it. I don't understand why they would put such a light duty tranny in a big truck. The MD3060 is good tranny that's the one they...

Hi Gts, I have another question hope u can answer. I'm looking at 04 FF auto, and Im wondering which Allison model they used in this rig?

Good to know, I'm gonna be doing a drain and flush pretty soon on my 03 sg right now it's looking like a dirty green.

Compared to a hino 200hp auto this 9 speed has all kinds of power mind u I haven't driven a 250hp auto or 6speed to really compare but I can already tell by passing other cars and trucks in this thing with a 7-12,000lb load (mostly city driving with lots of hills) that its the extra gears in...

This is a box that's already off the truck and on the ground. It has barn doors and around 3" door frame on both sides and top. I'm beginning to think maybe i have to cut from the front, I'm gonna have to go out and have look at it again

I don't need a sleeper. I don't think I travel as far as most of u guys on here

I'm planning to shorten a 28' to a 24', what end would it be easier to shorten it from front or back?

Thx for the info Gts. I put antisieze on the new bolts and all moving parts and installed it, it's working like its suppose to :) I definitely saved myself some $$$ by taking it apart myself. I also decided to look at the idle knob and how it functions and it is turned all the way down, then...

I had soaked it in the lemon juice baking soda mixture it didn't do much so I sandblasted it, it was caked with rust n got nice and clean. After that went to buddy's place and he has a lot of machining tools and I ended up heating it up, worrying if there's any rubber seals that will melt but...

The local hino dealer says its $728 and there's no replacement parts for it. I'm soaking it in some lemon juice and baking soda mix and hopefully it frees up, if not I'm gonna have to put the machinist hat on!

Well I took off the exhaust brake and it's seized in the open position. The bolts are also seized and I managed to strip them all of them. So I'm gonna price this out now.

The actuator is working its the valve inside the exhaust brake that I believe is not moving. I sprayed some wd on the exhaust nuts I'm gonna attempt to take it apart tomorrow.

Thx for some of the tips. I'm gonna make my way in a few days to the dealership and get my answer on the transmission if it's been swapped or stock. I just found out today that the exhaust brake switch and indicator work but the exhaust brake itself doesn't. I checked the air actuator and that...