Try Hours
Bolt Express
Results 1 to 5 of 5
  1. #1
    Junior Member
    Join Date
    Jul 2005

    Installing E-Track

    Hellow everyone.I would like to know if anybody could tell me the the measurements for installing E-Track on the floor of my van.I have a new chevy 3500 extended.I plan on installing a 3/4" plywood floor.I also would like to know what kind of hardware to use to install the E-Track and the plywood.Any help would be appreciated.

  2. No Truck Age Restrictions!
    Nations Express
    Nations Express Truckload division, we pay a minimum of $1.10 per loaded mile plus the Fuel Surcharge. We also pay deadhead as follows. $0.75 per mile plus the Fuel Surcharge for miles 1 to 100 and then miles 101 and more are paid at $0.85 per mile plus Fuel Surcharge. Some of the benefits include: Company Paid Fuel Taxes No Forced Dispatch Home Weekends if you would like 24 Dispatch Assistance Weekly Pay Direct Deposit Com Data Fuel Card Freight Bill Scanning Paid Layover Detention Pay HAZ MAT Pay Fuel Discounts Tire Discounts Safety Bonuses Open Door Policy to Senior Management 2012 and 2013 Model 53 Foot Dry Vans No Trailer Rental Fees Down Payment Assistance Nations Express Uses the Nations Fuel Surcharge Average

  3. 1,197250,24362,9
  4. #2
    Senior Member
    Join Date
    Feb 2005
    Cambridge, Ohio, USA.

    RE: Installing E-Track

    I set my e-track at 17" from the wheel wells.1/4x2" stove bolts with lock washers spaced 12" apart.Then I sprayed undercoating on each bolt to keep the body metal from rusting around the bolts.

  5. 2,197251,24362,9
  6. #3
    Senior Member terryandrene's Avatar
    Join Date
    May 2004
    St. Peters, MO

    RE: Installing E-Track


    I don't like E-Track on the floor, but many others do like it there. It's always dirty in the slots and I'd worry about an errant skid nail or the broken leg of a 1500# metal tub fetching up in on of the slots too far forwad for a towmotor to reach.

    If you must, consider 1/2 inch plywood; you'll need the extra 1/4 inch height quite often to get a 4' tall skid in the rear opening. Another reason for the 1/2 inch ply is the E-track thickness is 1/2 inch so between the track and ply you'll have a flush floor. I'm not sure how the majority fastens the track to the floor but I'd use either construction or silicone adhesive to secure the plywood.

    For what it's worth, I use Baltic Birch plywood. It comes in 5x10' sheets so I cut them to contour with the wheel wells and outer van walls. It can't slide fore or aft when installed this way. Whatever type of wood you use, coat the surface with a waterbased urethane so it won't absorb oil and dirt and can be wiped clean rather easily.
    Terry and Rene'

    Cargo Van Owner/Operators.
    FedEx Custom Critical 1989 - 2008

  7. 3,197252,24362,9
  8. #4
    Senior Member Moot's Avatar
    Join Date
    Dec 2005
    Minnesota, U.S.A.

    RE: Installing E-Track

    On the Chevy there is a sheet metal pan at the rear underside. Here you need to use self tapping Tek screws with a hex head. Drill a pilot hole of a smaller diameter first. Also there is a heat shield where you will need the Tek screws. Otherwise use bolts where ever possible. Know where you are drilling! There are fuel lines, fuel tank and a spare tire to consider before drilling.

    I agree with Bryan, use an undercoating on all bolts and holes. Its messy but worth it. Lay down a tarp or cardboard, it drips. Also consider using stainless steel fastners.

    Terry is right, use construction adhesive to bond the plywood to the floor. A tube of PL-200 or Liquid Nails should do it.

    Buy a cheap small ratchet and a 10mm socket. It will come in handy on the occasions when you need to remove and re-install the door latch thing at the top of the door frame. This will give you an extra 1/2 to 3/4 inch clearance. I have talked to guys who have permanently removed this. I would advise against doing this. It must be there for a reason.

    "I guess that is why I enjoy expediting. Kinda like standing in front of a giant roulette wheel." davekc

    "I wonder why I'm not quoted at the bottom of Moot's posts?"
    Highway Star

    "Shane runs 70 PSI all around." scottm4211

    "Embrace the mundane." mrgoodtude

    "I think, therefore I van". Mouton Descrouton

  9. 4,197253,24362,9
  10. #5
    Junior Member
    Join Date
    Jul 2005

    RE: Installing E-Track

    Thanks everyone for the suggestions on installing the E-Track and floor.I have my reservations for the truck show in Louisville so maybe I can get some more ideas while i'm there. I also want to install a bulk head and bunk.Maybe I'll run into some of you at the show.Thanks again

  11. 5,197254,24362,9

Similar Threads

  1. E Track
    By keith111475 in forum General Expediter Forum
    Replies: 6
    Last Post: 02-23-2009, 09:57 PM
  2. E track
    By dean07 in forum Truck Talk
    Replies: 2
    Last Post: 08-14-2008, 06:58 PM
  3. installing a cd player in my truck
    By rdtrpn in forum The Tech Shop
    Replies: 2
    Last Post: 01-15-2008, 09:55 AM
  4. e-track
    By terryandrene in forum The Newbies Paradise Forum
    Replies: 1
    Last Post: 10-13-2007, 12:19 PM
  5. Installing floor and e-track
    By C5BILL in forum The Newbies Paradise Forum
    Replies: 9
    Last Post: 08-23-2005, 07:05 AM

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
ExpeditersOnline.Com Copyright © 1999-2011 On Time Media, LLC. All Rights Reserved.
ExpeditersOnline.com © is a registered trademark of On Time Media, LLC

Search Engine Optimization by vBSEO 3.6.0 PL2